ÖÐÎÄ°æ¡¡ENGLISH
Service
FAQPresent Residence Address£ºHomepage >> FAQ
How to upgrade the TV software?
Published£º2014-4-25
 

How to upgrade the TV software?

 

The motherboard with the FLASH ROM storage procedures, which can be repeatedly erased, can be pre-recorded the software to the FLASH IC, and then load it to the appropriate location of the motherboard, or can be upgraded the software via a VGA port or a USB port. Procedures are related to the functions of the motherboard, that¡¯s to say, the motherboard with different functions or different solutions should be recorded with the different versions of the programs. In general, directly upgrading the software through the USB port is the most simple and efficient method.

 Take the motherboard solution MSTAR 6M181, 6M182 and 18VG as examples. Regarding those upgrading procedures and upgrading precautions , see the following:

 Directly upgrade the TV software via USB port :

1, Copy a new software in a USB disk, and then plug the USB disk into the TV's USB port;

2, Then connect the power supply to make the TV with "red light" on (Note: Just let the TV standby, but do not switch on). About 2 seconds later, you should find that the light will automatically enter the slow flashing; A few seconds later, the indicator light will change the state into "flashing" from blinking slowly, and finally stop flashing and change back to the ¡°red light¡± status (which indicates the upgrading is ended, and you can unplug the USB disk).

3, Turn off the TV power supply, then turn it on, and the upgrading operation will be completed.

 Please Note:

When the indicator is in blinking, it means that the upgrading process has been entered. At this time, do not power off ;

When the indicator light changes the state into "flashing" from blinking slowly, it means that the upgrading process will be completed quickly. Please wait for a while, until the indicator light stops blinking.

The quality for U disk used for upgrading software must be good, and it cannot have virus documents or other documents;

If the new software ¡°Bin file¡± is inside the RAR compressed file, then firstly you must unzip the corresponding the software Bin file from the pressure package, then copy the new software Bin file to the U disk directly;

The name of the Software Bin file cannot be changed, otherwise the upgrading operation cannot go on !

 

Previous Page£º The problem when you change to replacing screen panel
Next Page£º How to maintain remote?
About Us| Legal Notice| Social Recruitment| Web Map| Friendly Link| Contact Us
Address£ºNo. 88, Baotong Road (South)Shenzhen, Guangdong
Telephone£º+86 755-89739888¡¡Fax£º+86 755-89739666¡¡Email£ºsales@expressluck.com
Copyright © 2013 Express LUCK Industrial LTd.¡¡Technical Support£ºXinpai network¡¡ÔÁICP±¸10214925ºÅ